PEATY'S CHRIS KING MK2 TUBELESS VALVES 60MM

PEATY'S CHRIS KING MK2 TUBELESS 60MM VALVES are made of lightweight, high-strength 7075 aluminium and fit most tubeless configurations, from MTB to road and cyclocross, including carbon, enduro and DH rims.
The X-Cut base is designed to work with all tyre inserts. Hollowed-out channels in the valve base allow air and sealant to pass through when the inserts are pushed against them. Unlike most other insert-compatible valves, these have a 'direct passage' design, so there is no reduction in sealant or airflow when tyre inserts are not used.
Installation could not be simpler. The integrated o-rings prevent the locking rings from scratching your precious rims, and the wide soft rubber bases easily create a tight seal.
The valves have an integrated valve core removal cap and a spoke key cap (for standard 3.4 mm nipples). In this way, tightening loose spokes and topping up the sealant is child's play, both in the workshop and on the trails.

ASSEMBLY INSTRUCTIONS:

• Remove valve cap, o-ring and lock nut.
• Insert the valve into the hole in the rim.
• Push the o-ring onto the valve stem.
• Slide the lock nut onto the valve stem.
• Tighten the lock nut by hand until it is secure.
• Screw on the valve cap.